Holder Only Sold without products
IF ORDERING HOLDERS ONLY AND NOT TYNEHAM PRODUCTS PLEASE CHECK THIS HOLDER IS STILL SUITABLE FOR YOUR REQUIREMENTS.
Features Designed to hold our luxury 300ml products as well as many other high street brands. Lockable, with unique drop down feature for easy cleaning and loading.
Material 2.5mm stainless steel hand polished to a chrome finish.
Dimensions Back plate: L x 145mm W x 60mm D x 68mm. Space required to include loading of bottle due to front plate sliding downwards: L x 166mm W x 62mm.
Bottle Sizes Will hold bottles up to 62mm diameter x 120mm in height (top of shoulder).
Fixing Instructions For Single, Double and Triple Wall Mounted Holders.
Your holder is made from 304 certified stainless steel and should not rust but care needs to be taken when installing and cleaning your holders.
Hand Basin Location Fit allowing suitable height above and below holder for access for re-filling and changing the bottle. Recommended minimum height from work surface to bottom of holder = 10cm.
Shower Location If possible, locate the holder arms reach from shower head, not directly beneath it. A recommended minimum height from floor to bottom of holder = 100cm, and possible fit dispenser into a corner so not to be a hazard.
Fixing Remove Holder from bag and use as template to mark wall, drill using appropriate drill bit and fit plug, attach holder to wall.
Holders can be stuck to clean even surfaces using a good quality double sided tape as provided.
Make sure surface is dry and clean, use alcohol wipe provided to wipe surface and allow to dry. Once stuck, allow as much time (up to 24hrs) for adhesive to set before positioning bottles into dispenser.
1) Loosen screws with allen key, make sure front plate is fully down.
2) Load bottles by positioning pumps through large holes in top of holder.
3) Once bottles are positioned on front/base plate, slide plate up with bottle pumps through holes as far up as possible, tighten allen screws.
SoHo Dispensers does not install holders nor guarantees any of the fixing or tape supplied, due to different surfaces types.
Cleaning For care of your holder, we recommend removing bottles monthly and clean thoroughly using a micro fibre cloth and soapy water. If positioned in hard water areas, vinegar is recommended for removal of lime scale. Harsh chemicals or abrasive cleaners should not be used to clean these holders.
Warranty Our holders are guaranteed for two years against any manufacturing defects or operation. Holders are not guaranteed against misuse of cleaning. For locations in direct proximity to swimming pools or sea water, we recommend holders made from our 316 material. For more information please contact for support.
Tyneham does not install holders nor guarantees any of the fixing or tape supplied, due to different surfaces types.
Tyneham does not guarantee their holders against misuse of cleaning.
For maximum presentation keep bottles topped up at all time.
Made in England
Design Stephen King